Find a Stockist near you
The Standard Adaptor is used for installing a Hansen Trough or Tank Valve into a threaded inlet. BSPT x BSPT
Features and Benefits
Yes, the Super-Flo trough Valve incorporates a 25mm (1”) thread on the valve outlet which you can utilise the spare adaptors that come with the valve to enable you to attach any number of poly pipe fittings to the Super-Flo trough Valve. This off take can be used for any number of farm applications.
Yes, valve bounce is created from high flows at high pressures, because our Hansen Max-Flo valve delivers higher flows than other valves it will effectively reduce line pressure which in return will reduce the incidences of this problem by also reducing water hammer.
Yes, valve bounce is created from high flows at high pressures, because our Hansen Super-Flo valve delivers higher flows than other valves it will effectively reduce line pressure which in return will reduce the incidences of this problem by also reducing water hammer.
Yes, this is called water hammer, we have designed the Hansen Max-Flo Valve to open and close slower than other valves effectively varying the flows at these times to minimise the chance of water hammer.
Hansen does not recommend the use of any Hansen True Fit Fittings under any driveways, paths or foundations.
No, as the high concentration of chlorine used in the water for pools will attack the material. The fitting material is only suitable for use with domestic water. Hansen products that are used in this application will not be covered by our limited lifetime warranty.
Yes, the Hansen Max-Flo Valve can be installed at the top, side or bottom entry as all components come with each valve.
Yes. For more information on installation tips refer to installation instructions.
Yes. All pipe work must be adequately supported.
Yes, all Hansen manufactured products carry our Limited Lifetime Warranty*
*For more information about the Hansen Limited Lifetime Warranty, please visit the Legal Information link in the footer.
Yes, our range of HiFlo Valves are designed to handle dirty water. The Hansen Leveller Valve which is based on our diaphragm valves it is unique in that it has a pin that cleans the pilot hole in the diaphragm every time it opens and closes. In addition to that the gap between the diaphragm and the valve body when open is a huge 14mm further reducing potential blockages.
Do not over tighten. The right way to assemble a threaded fitting is hand tight plus one to two turns – no more! For more information on installation tips refer to installation instructions.
Yes, the Fast-Flo valve has the highest flow of any valve in its class/size. At 500 kPa (73psi) it will deliver 56 l/min
The noise while the tank is filling is caused by the high velocity of the water from the valve outlet into the tank. The Fast-Flo valve outlet doubles as a spigot so you can attach a length of hose to allow the flow to be placed onto the bottom of the tank eliminating this noise.
The noise while the tank is filling is caused by the high velocity of the water from the valve outlet into the tank. The Mini Fastflo valve outlet doubles as a spigot so you can attached a length of hose to allow the flow to be placed onto the bottom of the tank eliminating this noise.
No, the seat we use in Hansen Float Valves are urethane which is a very durable and hard material. The seal is also reversible if a foreign body should damage it.
Yes, this is called cycling and can drastically reduce the life of your pump. The Hansen Leveller Valve is designed to control your pump safely by eliminating pump cycling and providing an adjustable water differential depth in your tank.
Our patent pending “Self Cleaning Pilot” will increase durability and suitability in dirty water situations.
We have designed the Hansen Super-Flo valve to work in either clean or dirty water situations.
