Find a Stockist near you
Replacement Part for Hansen Maxflo & Mini Fastflo Valves.
25mm Stainless Steel Split Pin.
Yes, valve bounce is created from high flows at high pressures, because our Hansen Max-Flo valve delivers higher flows than other valves it will effectively reduce line pressure which in return will reduce the incidences of this problem by also reducing water hammer.
Yes, this is called water hammer, we have designed the Hansen Max-Flo Valve to open and close slower than other valves effectively varying the flows at these times to minimise the chance of water hammer.
Yes, the Hansen Max-Flo Valve can be installed at the top, side or bottom entry as all components come with each valve.
The noise while the tank is filling is caused by the high velocity of the water from the valve outlet into the tank. The Mini Fastflo valve outlet doubles as a spigot so you can attached a length of hose to allow the flow to be placed onto the bottom of the tank eliminating this noise.
No, the seat we use in Hansen Float Valves are urethane which is a very durable and hard material. The seal is also reversible if a foreign body should damage it.
Our patent pending “Self Cleaning Pilot” will increase durability and suitability in dirty water situations.
Yes, the Hansen Max-Flo Valve comes with the required components to install in 20mm or 25mm threaded inlets. This of course means you only need to buy one valve for all sized inlets.
Yes, the Mino Fast-Flo Valve has the arm pivot point positioned to allow closing at pressures up to 12 bar (174psi).
The Hansen Max-Flo Valve will operate from 0.2 bar to 12 bar.
All Hansen float valves carry a 25mm (1”) female thread on the valve inlet. This gives you a couple of benefits. The valve will fit inlets from 15mm to 50mm when using our range of adaptors. The additional material used at the inlet to form the female thread strengthens the valve at an area that has been identified as a weak point in other brands of valves.
Yes, the Mini Fast-Flo was designed as a compact valve for use in small bowls, compact troughs, feeders & header tanks or any situation where the valve space is confined.
No, because the Hansen Super-Flo valve is more efficient than what you are used to. The reduced operating pressure required will equate to higher flows at lower pressures at your pump which in turn will reduce pumping time and cost.
